Local Project Questions · 2 min read

A Leaking Above-Garage Deck: Why We Discussed More Than a New Finish

The caller reported leak damage above a garage. Our discussion covered replacement finishes, airflow, framing questions, and how coating repairs might look.

← Back to Blog

The caller wanted to discuss a new deck finish, but also reported a problem beneath the surface. They described coated plywood above a garage and said water intrusion had damaged the header beam above the garage opening. Our discussion covered the replacement finish and the assembly underneath it. The reported damage came from the caller; we had not verified it.

The top part is actually flat plywood with the coating on top.

Local caller

We first discussed how the deck boards would sit above the roof. For the assembly being discussed, we described raising the boards on two-by-fours to leave room for airflow rather than laying the boards flat against the surface.

It has to be sitting up off the roof to a couple inches so that it can allow airflow underneath the deck boards.

Our response

The caller then explained that the existing surface sat directly on top and had drainage and moisture problems. We explained that trapped moisture could lead to rot. The choice of finish could not be discussed on its own without also considering the assembly beneath it.

Are you guys using like epoxy on your floorings for decks or what are you guys doing?

Local caller

We discussed two approaches: a hot-mopped surface covered with deck boards, or a solid, concrete-based coating system. Whether the existing framing could support the heavier coating remained an open question. We discussed the possible need for stronger framing and asked how much foot traffic the caller expected.

I don't know whether we would have to beef up the framing to take that because it's somewhat heavier.

Our response

We also covered how repairs could look. Movement-related cracks in a solid coating could leave visible filled areas after repair. We said either approach was available and that the caller’s preference mattered. Our response did not identify one finish as the only choice.

Is there another material that's more like an epoxy coated, which is like a couple layers or something like that?

Local caller

When the caller asked again about layered epoxy, we described an epoxy topcoat with a slurry coat and finish coat. A base was still needed. Our explanation treated epoxy as one part of a layered system, not as a finish that would address the reported damage on its own.

Our discussion left more to consider than surface appearance. The caller still had moisture concerns, an unanswered framing question, and the possibility of visible coating repairs to weigh alongside their finish preference.

Talk with us about your deck’s reported moisture concerns, finish preferences, and any unresolved framing questions.

Ready to Get Started in Temecula?

Contact Apex Deck Solutions today for a free, no-obligation estimate on your project.

Get Your Free Quote